Fuootech Oil Filtration Group
Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System
  • Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System
  • Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System
  • Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System

Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System

It is special for treating & regenerating the 
used and old transformer oil, mutual oil, and 
switch oil, which power transformers 
are above 110 kV.

  • Share This Post:

     It is special for treating & regenerating the used and old transformer oil, mutual oil, and switch oil, which power transformers are above 110 kV.

     

     Comparing with the single stage type, this machine adopts the double stages vacuum system, which can improve the machine working vacuum value highly, so it can dewater, degas and remove the impurity more deeply with high speed. Also it can inject the insulating oil into the transformers on-line. Regenerate the seriously deteriorated oil by removing the polarity materials. This machine is specially applied to vacuum filling oil and drying for power transmission equipments that are over 110KV.

     

     Oil Result after Regeneration                                        

    Moisture (Water Content)

    ≤ 4 PPM

    Gas Content

    ≤0.01% (Vol)

    Impurities Degree (Filtration precision)

    ≤ 3 micron (no free carbon)

    Breakdown Voltage (Dielectric)

    ≥70 KV

    Flash Point

    ≥145

    PH Value

    5.5

    Acid Value

    0.03mgkoH/g

    Dielectric loss

    tgδ(90)%0.001

    Cleanliness

    ≤NAS 1638 Grade 6


     High vacuum:  Ultimate Vacuum degree≤5pa, Working-vacuum≤35pa

     Duplex 3D stereo-evaporation technology resulting in eliminating the liquid water content quickly and separating gas/air content fast.

     

     UK G technology is adopted to remove trace water, dissolved water effectively and thoroughly.

     High-tech FH Trapezoidal networking Filtering technology with multi-stage filtering materials ensure the distinctive particles & impurities removal.

     

     Carbon fiber infrared heating system that can make the oil contains zero sum of ethyne after the regeneration.

     Adopt interlocked protective system, which connect oil pump, heater and liquid level sensor, avoiding blank heating, blank pumping, oil leak and electricity leak. If there is any fault, machine will be power off automatically.

     Double-infrared liquid level controlling system keep oil inlet and outlet quantity balancing while operation fully automatically.

     Special Oil Regeneration system installed on it which help recover more oil’s property, letting oil be more closer to new oil’s standard

     

    Parameters

    Model

    Unit

    ZYD-I-30

    ZYD- I-50

    ZYD- I-100

    ZYD- I-150

    ZYD- I-200

    ZYD- I-250

    ZYD- I-300

    Flow Rate

    L/H

    1800

    3000

    6000

    9000

    12000

    15000

    18000

    Working Vacuum Degree

    MPa

    -0.08 ~ -0.099

    Working

    Discharge Pressure

    MPa

    ≤ 0.3

    Temperature

    Control Range

    20 ~ 80

    Operation Temperature

    40 ~ 70 (65℃ is best)

    Power Supply


    380V, 50Hz, 3 phases (or as per your requirements)

    Working hours

    without Trouble

    Hour

    4000

    Continuous Working Hours

    Hour

    150

    Ambient Temperature


    -25 ~ 55℃

    Working Noise

    dBA

    65 ~ 90

    Heating Power

    (adjusted available)

    KW

    30

    36

    48

    60

    72

    80

    120

    Total Power

    KW

    35.5

    42

    52.5

    68

    82

    93

    135

    Inlet/Outlet

    mm

    φ25

    φ32

    φ42

    φ50

    φ50

    φ60

    φ60

    Weight

    Kg

    600

    700

    1050

    1150

    1450

    1600

    1950

    Dimension

    Length

    mm

    1380

    1610

    1750

    1850

    1950

    2050

    2200

    Width

    mm

    1020

    1250

    1350

    1400

    1500

    1600

    1750

    Height

    mm

    1760

    1950

    2150

    2200

    2300

    2400

    2550

    Note:     1. The dimension and weight will be changed with changing of technical specs.

                  2. All the specs can be customized according to client's requirements.

     

        For more info, pls don't hesitate to contact us.

    CONTACT US
  • NO.5 Hongshi Street, Jiulongpo District, Chongqing, China
  • +86 135 2739 0908
  • +86 23 8823 9845
  • +86 23 8823 9845
  •        info#fuootech.com
           (please change # to @ when you need send us inquiries by email.)
Top
Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System

Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System

It is special for treating & regenerating the 
used and old transformer oil, mutual oil, and 
switch oil, which power transformers 
are above 110 kV.

     It is special for treating & regenerating the used and old transformer oil, mutual oil, and switch oil, which power transformers are above 110 kV.

     

     Comparing with the single stage type, this machine adopts the double stages vacuum system, which can improve the machine working vacuum value highly, so it can dewater, degas and remove the impurity more deeply with high speed. Also it can inject the insulating oil into the transformers on-line. Regenerate the seriously deteriorated oil by removing the polarity materials. This machine is specially applied to vacuum filling oil and drying for power transmission equipments that are over 110KV.

     

     Oil Result after Regeneration                                        

    Moisture (Water Content)

    ≤ 4 PPM

    Gas Content

    ≤0.01% (Vol)

    Impurities Degree (Filtration precision)

    ≤ 3 micron (no free carbon)

    Breakdown Voltage (Dielectric)

    ≥70 KV

    Flash Point

    ≥145

    PH Value

    5.5

    Acid Value

    0.03mgkoH/g

    Dielectric loss

    tgδ(90)%0.001

    Cleanliness

    ≤NAS 1638 Grade 6


     High vacuum:  Ultimate Vacuum degree≤5pa, Working-vacuum≤35pa

     Duplex 3D stereo-evaporation technology resulting in eliminating the liquid water content quickly and separating gas/air content fast.

     

     UK G technology is adopted to remove trace water, dissolved water effectively and thoroughly.

     High-tech FH Trapezoidal networking Filtering technology with multi-stage filtering materials ensure the distinctive particles & impurities removal.

     

     Carbon fiber infrared heating system that can make the oil contains zero sum of ethyne after the regeneration.

     Adopt interlocked protective system, which connect oil pump, heater and liquid level sensor, avoiding blank heating, blank pumping, oil leak and electricity leak. If there is any fault, machine will be power off automatically.

     Double-infrared liquid level controlling system keep oil inlet and outlet quantity balancing while operation fully automatically.

     Special Oil Regeneration system installed on it which help recover more oil’s property, letting oil be more closer to new oil’s standard

     

    Parameters

    Model

    Unit

    ZYD-I-30

    ZYD- I-50

    ZYD- I-100

    ZYD- I-150

    ZYD- I-200

    ZYD- I-250

    ZYD- I-300

    Flow Rate

    L/H

    1800

    3000

    6000

    9000

    12000

    15000

    18000

    Working Vacuum Degree

    MPa

    -0.08 ~ -0.099

    Working

    Discharge Pressure

    MPa

    ≤ 0.3

    Temperature

    Control Range

    20 ~ 80

    Operation Temperature

    40 ~ 70 (65℃ is best)

    Power Supply


    380V, 50Hz, 3 phases (or as per your requirements)

    Working hours

    without Trouble

    Hour

    4000

    Continuous Working Hours

    Hour

    150

    Ambient Temperature


    -25 ~ 55℃

    Working Noise

    dBA

    65 ~ 90

    Heating Power

    (adjusted available)

    KW

    30

    36

    48

    60

    72

    80

    120

    Total Power

    KW

    35.5

    42

    52.5

    68

    82

    93

    135

    Inlet/Outlet

    mm

    φ25

    φ32

    φ42

    φ50

    φ50

    φ60

    φ60

    Weight

    Kg

    600

    700

    1050

    1150

    1450

    1600

    1950

    Dimension

    Length

    mm

    1380

    1610

    1750

    1850

    1950

    2050

    2200

    Width

    mm

    1020

    1250

    1350

    1400

    1500

    1600

    1750

    Height

    mm

    1760

    1950

    2150

    2200

    2300

    2400

    2550

    Note:     1. The dimension and weight will be changed with changing of technical specs.

                  2. All the specs can be customized according to client's requirements.

     

        For more info, pls don't hesitate to contact us.

    CONTACT US
  • NO.5 Hongshi Street, Jiulongpo District, Chongqing, China
  • +86 135 2739 0908
  • +86 23 8823 9845
  • +86 23 8823 9845
  • Contact Us   Sitemap
  • Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System

    Series ZYD-I Double Stage Vacuum Transformer Oil Regeneration System

    It is special for treating & regenerating the 
    used and old transformer oil, mutual oil, and 
    switch oil, which power transformers 
    are above 110 kV.

    • Share This Post:

       It is special for treating & regenerating the used and old transformer oil, mutual oil, and switch oil, which power transformers are above 110 kV.

       

       Comparing with the single stage type, this machine adopts the double stages vacuum system, which can improve the machine working vacuum value highly, so it can dewater, degas and remove the impurity more deeply with high speed. Also it can inject the insulating oil into the transformers on-line. Regenerate the seriously deteriorated oil by removing the polarity materials. This machine is specially applied to vacuum filling oil and drying for power transmission equipments that are over 110KV.

       

       Oil Result after Regeneration                                        

      Moisture (Water Content)

      ≤ 4 PPM

      Gas Content

      ≤0.01% (Vol)

      Impurities Degree (Filtration precision)

      ≤ 3 micron (no free carbon)

      Breakdown Voltage (Dielectric)

      ≥70 KV

      Flash Point

      ≥145

      PH Value

      5.5

      Acid Value

      0.03mgkoH/g

      Dielectric loss

      tgδ(90)%0.001

      Cleanliness

      ≤NAS 1638 Grade 6


       High vacuum:  Ultimate Vacuum degree≤5pa, Working-vacuum≤35pa

       Duplex 3D stereo-evaporation technology resulting in eliminating the liquid water content quickly and separating gas/air content fast.

       

       UK G technology is adopted to remove trace water, dissolved water effectively and thoroughly.

       High-tech FH Trapezoidal networking Filtering technology with multi-stage filtering materials ensure the distinctive particles & impurities removal.

       

       Carbon fiber infrared heating system that can make the oil contains zero sum of ethyne after the regeneration.

       Adopt interlocked protective system, which connect oil pump, heater and liquid level sensor, avoiding blank heating, blank pumping, oil leak and electricity leak. If there is any fault, machine will be power off automatically.

       Double-infrared liquid level controlling system keep oil inlet and outlet quantity balancing while operation fully automatically.

       Special Oil Regeneration system installed on it which help recover more oil’s property, letting oil be more closer to new oil’s standard

       

      Parameters

      Model

      Unit

      ZYD-I-30

      ZYD- I-50

      ZYD- I-100

      ZYD- I-150

      ZYD- I-200

      ZYD- I-250

      ZYD- I-300

      Flow Rate

      L/H

      1800

      3000

      6000

      9000

      12000

      15000

      18000

      Working Vacuum Degree

      MPa

      -0.08 ~ -0.099

      Working

      Discharge Pressure

      MPa

      ≤ 0.3

      Temperature

      Control Range

      20 ~ 80

      Operation Temperature

      40 ~ 70 (65℃ is best)

      Power Supply


      380V, 50Hz, 3 phases (or as per your requirements)

      Working hours

      without Trouble

      Hour

      4000

      Continuous Working Hours

      Hour

      150

      Ambient Temperature


      -25 ~ 55℃

      Working Noise

      dBA

      65 ~ 90

      Heating Power

      (adjusted available)

      KW

      30

      36

      48

      60

      72

      80

      120

      Total Power

      KW

      35.5

      42

      52.5

      68

      82

      93

      135

      Inlet/Outlet

      mm

      φ25

      φ32

      φ42

      φ50

      φ50

      φ60

      φ60

      Weight

      Kg

      600

      700

      1050

      1150

      1450

      1600

      1950

      Dimension

      Length

      mm

      1380

      1610

      1750

      1850

      1950

      2050

      2200

      Width

      mm

      1020

      1250

      1350

      1400

      1500

      1600

      1750

      Height

      mm

      1760

      1950

      2150

      2200

      2300

      2400

      2550

      Note:     1. The dimension and weight will be changed with changing of technical specs.

                    2. All the specs can be customized according to client's requirements.

       

          For more info, pls don't hesitate to contact us.

    CONTACT US
    • NO.5 Hongshi Street, Jiulongpo District, Chongqing, China
    • +86-135 2739 0908
    • +86 23 8823 9845
    • +86 23 8823 9845
    •        info#fuootech.com
             (please change # to @ when you need send us inquiries by email.)