When cleaning impurities in the vacuum oil filter, pay special attention to the stainless steel wire mesh on the filter element not to be deformed or damaged, otherwise, the filter is installed, and the purity of the filtered medium cannot meet the design requirements. Compressors, pumps, instruments and other equipment Will be damaged; if the stainless steel wire mesh is found to be deformed or damaged, it needs to be replaced immediately. The filter element of the oil filter is composed of special materials, which are suitable for wear and need special protection; when the precision filter has been working for a period of time, the filter element will hold a certain amount of impurities, and the pressure drop will increase and the flow rate will be reduced. When descending, the impurities in the filter should be removed in time, and the filter element should be cleaned at the same time.
1. First of all, the filter element must be maintained and cleaned regularly, until the filter element cannot be cleaned, it must be replaced with a new filter element immediately. Because the filter element has been used for a period of time, it will intercept a certain amount of impurities and block the aperture of the filter element. If it is not removed, it will slow down the flow rate of the oil during oil filtration, reduce the working efficiency of the oil filter, and the filtering effect will also change. Poor, so the filter element needs to be cleaned and replaced regularly.
2. Secondly, pay special attention to the stainless steel wire mesh when cleaning the filter element of the vacuum oil filter. The stainless steel wire mesh is a vulnerable part. It is easy to be damaged or deformed if you do not pay attention to it. If the stainless steel wire mesh is damaged or deformed, it should be timely Replace to ensure that the filtering effect is not affected. Because once the steel mesh gap is deformed or damaged, the filtration accuracy and effective filtration ratio of the filter element will definitely be implicated.
3. After each use of the vacuum oil filter, if you plan to leave it unused for a period of time, you must clean the residual oil in the filter cartridge, and don't let the filter element keep soaking in the residual oil. After long-term work, some dirt and impurities will also be deposited on the wall of the filter cartridge of the vacuum oil filter. When the equipment is not going to be used, the filter element can be taken out and the filter cartridge can be cleaned up in time. So as not to accumulate more and more dirt the next time you start the device.
4. The stainless steel wire mesh of the vacuum oil filter is a wearable part and needs special protection; when the filter has been working for a period of time, certain impurities have precipitated in the filter core. At this time, the pressure drop will increase and the flow rate will decrease, so it needs to be removed in time. Impurities in the oil filter core.
