We often buy hydraulic oil vacuum oil purifiers when we reduce the production cost of enterprises, but how do we use this equipment after we buy it?
1. When operating on site, the oil filter should be as close as possible to the oil tank we prepared, and the oil suction pipe should not be too long to reduce the resistance of the pipe.
2. Before connecting the pipeline and the fuel tank, we must do a good job of cleaning beforehand, and the pipeline and the fuel tank have good airtightness.
3. Operate strictly in accordance with the operating procedures. When starting the oil filter, it is necessary to wait until the vacuum pump, oil pump and heater are all operating normally and the internal circulation is normal, then the oil can be circulated and filtered.
4. When the oil that needs to be filtered contains a lot of mechanical impurities and moisture, we must remove the moisture and impurities at the bottom in advance, and then use other filtering equipment (pressure oil filter, centrifugal oil filter) to fully filter Divided by the standard of crude oil requested by the hydraulic oil vacuum oil filter, the hydraulic oil vacuum oil filter can be used for filtering, so as not to affect the service life of the equipment.
5. During the operation of the equipment, we must strictly monitor the operation of the equipment (such as flow, temperature, vacuum, etc.), and regularly check the quality of the oil before and after filtration (impurities, moisture, etc.). In order to observe the purification effect and ability of the equipment.
6. When we use the equipment in winter, we must use heat preservation methods for pipelines, vacuum tanks and other parts to prevent the equipment from being unable to operate normally due to the low outside temperature. In addition, we must abide by the relevant regulations in the electric safety operation regulations issued by the electric power industry when using the substation.








