Due to system leakage, poor sealing, long-term thermal load of the oil, open oil storage, etc., moisture and gas in the air seep into the oil, resulting in water and gas in the oil.
Due to system leakage, particulate dust in the air enters or system wear and dust fall off, long-term operation of oil under high temperature and water content will inevitably lead to partial oil cracking and deterioration to precipitate colloidal substances.
The hazards of water, gas, and impurities in the oil:
The oil is rapidly oxidized and deteriorated to produce acidic substances, which corrode the metal contact surface;
The additive precipitation in the oil fails, the thickness of the oil lubricating film is reduced, and the wear of the mechanical contact surface is intensified;
Oil lubrication, cooling, and flow properties are reduced, which accelerates metal surface fatigue;
Ice crystals formed at low temperature block the components;
The oil system responds slowly and is accompanied by irregular movements, and the conduction performance is reduced;
The fuel pump and power equipment are damaged by cavitation.
The performance index of lubricating oil largely depends on the water content, gas content, impurities in the oil and the pollution degree of the oil. In order to enhance the oil lubrication performance, the oil must be dehydrated, degassed, and impurities removed under the rated vacuum and temperature.
Then it is necessary to use a special oil filter to filter the lubricating oil, so as to ensure the performance of the lubricating oil.







