The main purpose of the lubricating oil vacuum oil filter is to treat unqualified turbine oil, especially suitable for heavily emulsified turbine oil, which can quickly and efficiently remove water, gas, and impurities in the oil, so as to improve the quality of the oil. Reach the new oil standard to ensure the safe operation of the steam turbine unit. So, how to use the lubricating oil vacuum oil filter? This is a question that many users want to understand. Let's go to understand the use of the lubricating oil vacuum oil filter together:
Connect the oil inlet pipe of the equipment to the oil outlet of the oil tank to be treated, and the oil outlet to the oil inlet above the oil tank to be treated.
Open the electrical box, check whether all electrical components are intact, whether they are loose or wet, remove debris, and connect the main power and ground wires. Close the power switch.
Open the shut-off valve in front of the water separator and the shut-off valve below, the return valve under the demister, the shut-off valve under the condenser, and the shut-off valve in front of the fine filter. All other valves are closed.
Start the vacuum pump and start working. The operation indicator of the vacuum pump is on. Observe that the negative pressure of the vacuum gauge reaches the specified value; (usually close to -0.08MPa). After the vacuum pump is running normally, open the oil inlet valve and observe the inside of the vacuum cylinder. Wait until the oil enters the back of the vacuum cylinder. The heater can be activated.
After the oil pump is running normally, set the temperature of the temperature controller. For the temperature setting method, please refer to the temperature controller instruction manual. If the oil temperature is lower than the set value of the temperature controller and the oil level in the heater reaches the sensor control point, the heater will start heating.
When the oil level reaches the lower window of the vacuum cylinder, open the oil outlet valve and start the oil drain pump. (At the beginning of use, due to the moisture inside the machine or excessive water in the oil, you can slightly open the air valve to reduce the vacuum and eliminate bubbles.) If the turbine oil contains too much moisture, be careful during normal use As the oil foam rises, the oil foam must not exceed the upper window to avoid entering the vacuum pump and causing malfunction. After the machine is running normally, close the air inlet valve. In normal operation, it is necessary to control the rising and small rise of the oil foam and the vacuum degree to be controlled at about -0.08MPa.
Every time the machine runs for the first time, in order to put the oil filter into work as soon as possible to ensure that the oil is qualified, the circulation valve must be opened for internal circulation.
According to the specific working conditions, the regulating valve is about to be opened or about to be closed (the factory conditions are 0 altitude, horizontal oil inlet) to ensure that the oil inlet and outlet are basically balanced.
In case of emergency during operation, you can press the emergency stop button SBRS immediately, and the machine will stop working; if you need to resume work, turn the emergency stop button to the left to reset, and the machine will restart to work.







